![]() ![]() I almost gave up and was going to replace the module, but it seemed ok since the manual option worked, and when I turned it on, the lights would flash for 5-10 seconds which seemed like it was going thru some "boot" sequence. We replaced the Pool sensor and surprise, surprise, it worked. Finally in running some more tests, it seems like the pool sensor was also bad(not sure if I shorted it out in trying to get this to work), based on the chart in the manual, it was reading 140 f, so even with the dial set at 104, it would never come on. While this fixed the Check Sensor light, the heat would never go on automatically even though the Check Sensor lights were off. In trouble shooting that, we found that the wire for the Solar had broken so ran a new wire(thermostat) wire. Initially this started with the Check Sensor light flashing. I was finally able to get this sorted out. I wanted to thank you all for your reply. I wonder if the technician forgot to drill the hole for the sensor.ĭo you think this is why the automatic setting is not turning on? we live in AZ, so the daytime temp is really warm, and should start heating the water. We have had the unit for about 5 yrs with no issues, but late last year, we did have one of the collectors changed(Fafco) since it was leaking. This seemed strange but thought it was this way to get the outside temp, but not sure. The only thing I did notice is that the roof sensor was not connected into the pipe. If I slide the switch to manual, the value opens and it works, but the auto with the temp dial at the highest, does nothing. ![]() This stopped the Check Sensor from blinking. I replaced the sensor(one on the roof ofcourse) but that did not fix it(still blinked), so then saw there may have been a break in the wire, so replaced that. a few weeks back, the Check Sensor light started flashing. Built-in touch display for easy configuration and programming Fully programmable, automatic control of every output 4 High-voltage Relays upgradeable to 10 4 Valve Actuator Relays upgradeable to 8 Controls up to 16 EcoStar Pumps. We have an inground pool with the GL235 Control panel. Any pool or pool/spa combination Single and Dual Equipment Hayward Standard Features. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |